![]() Or, I noticed that the voltage across my spinner was only +4. The only two things I can think of is if I either need to put my left and right outputs on multiple pins at the same time. The instructions on cps2shock in japanese just show a 10 pin connector going to a 4 pin connector on the spinner. Controlling a paddle-like craft known as the Vaus, the player is tasked with clearing a formation of colorful blocks by deflecting a ball towards it without letting the ball leave the bottom edge of the playfield. In North America, it was published by Romstar. Well, I tried moving my spinner's left and right outputs all around to different pins on CN2 with no luck getting the game to see it. Arkanoid is a 1986 block breaker arcade game developed and published by Taito. After doing continuity tests, the four pins that are connected to those orange things give a high resistance rating to ground (like 915 ohms or so) while the pins not connected to the orange things give an infinite rating. If you look at the pictures of the adapter, it looks like there are four of those orange things (are those inductors?) next to CN2. A spinner has a 4-pin connector with the outer two pins being the left and right encoders, and the inner two pins being +5V and GND. Pins 1 and 10 are +5V and GND, leaving 8 different pins to go to two spinners. Well, I tried to fool around with the pinout with no luck. If you find out anything let me know as I would love to play mine with a spinner instead of a joystick. I'm pretty sure once you set it for the spinner it only uses left and right instead of all 8 directions. I wish there was an english version of the game. I tried searching and can't find any info on using the spinner but I would assume that it is exactly like the Taito F3 is where you can use either the joystick or spinner but for CPS2 instead setting a jumper you might have to activate it via the damn japanese menu. By looking at the PCB it looks like there is only 3 actual pins and the 4th is a ground. Only way to really find out what those pins are is to ground them 1 by 1. I've never seen that mini PCB before, did that come with your PL2 board? I didn't even know this game was played with a spinner until I just looked at the flyer and it has a picute with both a joystick and spinner. ![]() No I have it on CPS2, as far as the PS Analog I was talking about when i use a Jamma>PS2 converter I use. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |